10 Tips For Correctly Cutting Plywood
Posted: Wednesday, July 27, 2005
by cedarcreekwoodshop
Cedar Creek Woodshop
1. Avoid Cross Cutting - Plywood tends to chip the most when cut
across its width (grain). Cutting along the length of the wood
will help to reduce chipping.
2. Use the Right Blade - Special blades are manufactured for
different cutting jobs. The number of teeth, width, angle, and
rake of the blade all impact the cut. Choose a blade that best
matches your specific cutting situation.
3. Circular Saw - cut with the "Best Face" down.
4. Table Saw - cut with the "Best Face" up.
5. Score the Cut First - Run the plywood through the saw removing
only a minimal amount of wood. The next cut will leave a cleaner
cut.
6. Masking Tape - Put masking tape over the cut line to help keep the
fibers on the edge from pulling up.
7. Backing Panel - Attach a backing panel with strong double stick
tape. The backer board will take the brunt of the damage.
8. Use a Router - A router fitted with a straight bit will cut a
clean line. A pilot bit and straight edge will help provide a clean line.
9. Score with a Utility Knife - Score the cut line with a utility
knife.
10. Buy a Panel Scoring Setup - Some saws can be fitted with a
plywood panel scoring setup and are ideal if you have to cut a lot of plywood. The setup consists of a smaller blade that scores the
surface of the plywood before it reaches the cutter.
Brought To You Courtesy:
http://www.cedarcreekwoodshop.com Cedar Creek Woodshop
This Article has been viewed 1,827 times. (Not updated in real-time.)
No comments yet.We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.